Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
M17 Voice Using Mobilinkd TNCs
#1
M17 Voice OTA (over the air) is now possible using the Mobilinkd M17 KISS HT Android app (forked from Codec2Talkie), either a Mobilinkd TNC3 or Mobilinkd NucleoTNC, and a 9600-baud capable radio (requires direct access to the discriminator and modulator).  They has been tested with a Kenwood TM-V71A and  Kenwood TK-790.

The TX chain is Android App -> TNC -> Radio.

The RX chain is Radio -> TNC -> Android App.

The radio handles FM modulation/demodulation.

There is a physical connection between the radio and the TNC/Modem.

The TNC handles M17 baseband physical layer and data link layer encoding and decoding. This includes 4-FSK modulation/demodulation, sync word recognition, framing, convolutional encoding/decoding, Golay encoding, LICH assembly (if needed) and Link Setup Frame validation.

The TNC communicates with the Android app via KISS streaming protocol.  Currently USB Serial and BLE are supported transports.

The Android app is responsible for the UI, constructing or decoding the Link Setup Frame, audio input/output, and Codec2 encoding.  It currently only supports Codec2 3200bps mode.

The Android app can be found here: https://github.com/mobilinkd/m17-kiss-ht/releases
The NucleoTNC firmware can be found here: https://github.com/mobilinkd/NucleoTNC/releases
The TNC3 firmare can be found here: https://github.com/mobilinkd/tnc3-firmware/releases
Currently, the only config app that can be used to configure the NucleoTNC or TNC for M17 is the Python config app: https://github.com/mobilinkd/tnc1-python-config

Make no mistake, the firmware is highly speculative right now, designed to provide a working M17 voice implementation for M17 developers and experimenters.
Reply
#2
The config app for NucleoTNC cannot be compiled successfully in windows 10 or Linux (tried Ubuntu, Fedora). I also try to install the rpm file in Linux also fail.

Does it possible to offer the compiled exe file for windows 10?
Reply
#3
(06-26-2021, 09:02 PM)VR2XKP Wrote: The config app for NucleoTNC cannot be compiled successfully in windows 10 or Linux (tried Ubuntu, Fedora). I also try to install the rpm file in Linux also fail.

Does it possible to offer the compiled exe file for windows 10?

There is a Windows MSI linked in the NucleoTNC docs.

https://nbviewer.jupyter.org/github/mobi...figuration
Reply
#4
Thank you for your reply.

But the windows MSI on your link is 2019, and it seems not support 9600 & M17.

The latest is 4-Jan-2021 is here:
https://github.com/mobilinkd/tnc1-python...tag/v1.2.0

As mention above, I cannot install it (or compile) successfully in a Linux environment, and in windows 10 environment.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)